Cable Towers
Does the weight stack pin work with the Cable Tower?
No, the weight stack pin cannot be used with the cable tower as it would get caught on the cables in the inside of the machine.
Can you convert a plate loaded cable tower to a weight stack cable tower?
No, it’s not possible to convert, as each version of the cable tower has a different orientation and shares so few parts that an upgrade kit isn’t practical to offer. Instead, it’s more efficient to purchase the unit in the style you need or...
Does the Cable Tower come with a 2-1 cable adapter
Yes, the 2-1 cable adapter is included.
Does the Cable Tower come with nylon or TPU cables
TPU cables are included with the Cable Tower. Upgraded nylon cables are available to purchase on Spare Parts page: https://bellsofsteel.us/collections/spare-parts/products/cables-for-weight-stack-cable-tower
Does the Cable Tower come with handles?
Yes. a pair of nylon handles are include with the Cable Tower.
What are the hole centres for the slotted brackets?
The bottom is 4-9" from the floor, the top is 72-77" from the floor. (slotted holes from centre of bottom most hole to centre of top most hole)
Is rack, wall, or floor mounting hardware included?
No, mounting hardware is not included.
How can I mount the Cable Tower to the wall?
Step 1: Install the Stringer Board (the board the brackets will mount to) Decide where the cable tower will go and mark the height for the stringer board. Choose the correct fasteners based on your wall type: Concrete wall: Use Tapcon screws....
Can I attach the Cable Tower it to any rack?
Yes, it can attach to most power racks with a minimum height of 74 inches and 5/8-inch holes on the uprights.
Is a rear upright necessary?
Depending on your set up, no. Typically the rear upright is good for storage, or stability if you are only floor mounting the unit, but it is not needed, and has limited usability when the unit is fully wall mounted. You could grab some utility...
What rack attachments are compatible with the Cable Tower?
The Cable Towers are compatible with 2.3" x 2.3" (5/8" Holes) rack attachments.